Recent content by lightheaded

It is much easier with the sub model after I figured it out. I was having a problem with it till Merryoncherry explained it step by step. I was sequencing the custom model not the submodel. When I started sequencing on the submodel everything was perfect. I didn't know to click on the custom...

Finally got it figured out. Thank you very much

Ok I'll give it a try. Thanks for your help. I'm not going to due much more than this. My display is more static. My niece wanted a shooting star. on the roof.

Looks like I typed in the wrong value. I'm going to change that. After I figured it out its actually pretty easy. I'm going to sit down and work on a custom model. I have null pixels in the middle of the matrix which I couldn't figure how to due that.

Finally worked it out. Went the route of virtual strings. Tried to do a custom model, but couldn't figure it out. Maybe I'll try again later (knowledge is power). Here is how i did it. Hope this helps anybody...

That is correct. Just want to be able to break it down easily. I'm try to do virtual strings , but it not showing up in the visualizer. I'm able to create virtual strings in my controller software, but it won't download so it is not showing up in xlights. I dont mind using up 12 ports, because...

Tested it with the 150 at 30 percent worked good. I'll be trying that this week I'll let you know how I made out, If not a splicing I will go.

Yes I wanna take it apart for storage. 12volt regulated pixels. I'm just learning xlights . Just don't wanna cut the stings. I'm willing to do a custom model but don't know where to start.

I have 3- 2 foot by 8 foot matrices that I will be putting end to end to create a 2 foot x 24 foot matrix. Each matrix is 48 nodes wide. I don't want to cut the pixels. for each matrix. how would I accomplish this. # strings 12 , nodes per string 144, strands 1. I'm using 12 strings so I wont...