Recent content by Renzo1975

Data cable had a loose solder (from 4 yrs ago).. fixed now.. :-)

It's 12V yes and it does work again if I unplug and replug it back in.. Data amp? I'll have a look. It's only 400 nodes and has worked fine for the last few years. but I'll research into that... thanks.

Hi All, Running my system off FPP no issues.. Noticed about an hour in, the candy canes become stuck on this light pattern. No flashing or anything - just static but bright. Doesn't change during the breaks between songs just remains the same. I assume it could be a wiring issue but just...

Hi all, I'm after something (a quick connect clip or something?) to connect pixel strip to wires? I can't seem to find any local that are not at least $2 each. I bought a bucketload of solderless sleeves but I need something I can attach easily to pixel strip copper pad and then wires...

Hey thank you.. I did find an STL on the Baldrick 8 site but said it's for Meanwell. Mine's a SCOTT S-200-5 so i'm going to print it out and see how it goes.. I think about 2ishmm difference if I measured right so I'll report back.. Thank you for your help tho

Good morning all, Got my Baldrick 8 and S-200-5 power supply all delivered and ready to use. Does anyone happen to have an STL for this power supply to mount the Baldrick 8 on at all? There are STL files on the website but they seem to be meanwell. Thank you.

Thank you. You are amazing! Looking forward to adding more lights :-)

@Johnnyboy Love the share thanks. Has helped out heaps and impressive.. Quick q - Baldrick 8 - I'm getting one hopefully today for my 5v pixels (600 pixel matrix 2 inch spacing).. I assume you just plugged your baldrick 8 into your f16v3 spare port (ie: switch one) then ran it from there? Feel...

This post has been a lifesaver too... So clean and simple to understand... Perfect for my snowflakes now... Thank you so much :-)

Thank you..

That is awesome.. Thank you everyone... Do you happen to know which Bunnings U channel you got? I could prob print some spacers out (to justify buying the printer lol).. Any reason it's not straight on the coro and using a spacer? May help me attempt to roof mount too (have to find something to...

Nice.. thank you...Will grab some U channel and some bolts/ washers and get it hooked up... ta... wiring backwards too since my control box is right next to the last S in Christmas :-)

Hey guys, I'm wondering if you can help me out. I got the Merry Christmas chroma letters and I'm trying to work out the best way to mount them together and on my tile roof right at the front near the gutter. I'm trying to hunt down maybe some Bunnings u channel with a 10 mil ID that I can slot...

Ok. I connected everything up and every way I try, nothing happens lol.. Although the lights do work when plugged into normal 24v... AND when I turn the control box off, the lights cycle right at the end - so they are capable of getting power - it's just how to access and which port lol...Might...

Hey, According to the manual, it should do DMX and it's just the board and a power supply I've hooked up to the f16v3 correct port and all. I chose DMX but wasn't sure what the original owner had chosen... can't recall who either :-( Not sure what to do here lol.. but your serial DMX thingy...