Mine was pretty simple in the end.. I can't count :)
I just needed to add a remap for the next 4 pixels in the next universe on the ECG-P2 and that sorted it out for my issue.
My candy canes are 8 modules each so I had only remapped half of the one that is wired in reverse
i'm guessing this should be a relatively easy fix (other than the obvious rewire it solution)
I have three coro candy canes and stupidly glued the led's in the wrong direction for one of them. I'm using xLights for sequencing, FPP to run the show and ECG-P2's for my controllers,
The LED...
So I've been to busy to think about the CLAP this year and finally pulled my finger out.
Anyone still ordering from Ray and what's my chances of anything making it here before December?
How the blinking heck >:( can a delivery from Mainland China, that travels via Hong Kong then Singapore take just over 24 hours to get to Melbourne..
But good old Aussie Post takes three blinking days to get it from Melbourne airport to Mornington
(for those not familiar with Melbourne...
Well after a bit of to and fro, DHL tracking says my lights have just been cleared by customs in Melbourne!!
:)
Assuming Aussie post don't bugger up the last leg of the journey I will have a busy weekend ahead.
Lesson learnt and will order earlier next year.
Although I have realised...
UPDATE..
Status has changed to shipped overnight so at least were are getting somewhere..
With any luck DHL won't lose it and I will be very busy on the weekend ;D