Ok I must be missing something because I have been researching and can not find anything about getting LOR hardware to recognize the Enttec open DMX.[/size]I have the Enttec open connected to the computer. I have a DMX 6803 decoder connected to the Enttec and the strip connected to the decoder...
At first I thought this was the only way to do it (with the CCR controller) and I didn't understand DMX. Now it's starting to come to me and now I am looking for the least expensive way to produce the same effect.
I purchased the CCR controller to play with it and so far it has not work (I...
I think you may be able to connect 2 strips together by injecting power so you could possible get two strips (acting like CCR's) for as little as $180 ish
Hey Jon,
Here is where you order the CCR controller.
http://store.lightorama.com/cocorireco.html
BUT......I am working on something else that may be a lot cheaper. I am sure most of the guys on here have already done it as I am new and trying to figure this whole thing out. I am...
Hey Jon I just purchased the controller to see if I can that it working. If I can then next step getting them to work with DMX (that's if I can do it, I am not very knowledgeable with this yet).
I wouldnt power this up until you confirm your connections are correct to the controller or else it will damage the first pixel section of the strip
Now you tell me. Thanks a lot LMAO; thats what DIY is all about learning what to do but most importantly what not to do. I am going to continue...
Ok I am stuck. I have been researching for about a week now and have not found anything. So here it goes. I purchased a CCR controller to attempt to connect http://www.ebay.com/itm/Dream-Color-RGB-5M-5050-Flash-LED-Strip-Light-94-change-6803-IC-Chip-/320762993347
which I purchased from ebay...