12v / 12 channel remote control

[strobe dave]

hi again all,
along with my vixen running my lights i also have a few static 12v DC lights to turn on for my display, i came across this on ali express and wondered if anyone has used these before. as it would make life a lot easier for me to turn them on.
http://www.aliexpress.com/fm-store/507574/211271126-502660166/Free-shipping12V-12-CH-Radio-Controller-RF-Wireless-Remote-Control-Switch-system-transmitter-and-receiver-.html.
cant quite make out the wire set up but it does say can be used for 12v DC.

 

[fasteddy]

Nice find thanks for sharing

 

[David_AVD]

That board looks like it should switch low voltage ok. Pay no attention to the 20A @ 14V relay rating as that's pure fantasy. Without seeing a board close up, I would only trust the switching for 5A max due to the PCB tracks. Those terminal blocks would be rated to 10A I'd say.

 

[Superman]

There was one od these or very similar at the Melb Mini last year in a LOR setup. It was used to trigger inputs on LOR boards for stand alone operation. Worked very well.

 

[Bill Ellick]

These have been available on eBay for a long time now:
http://www.ebay.com/itm/12-CH-RF-Wireless-Remote-Control-Momentary-Toggle-Latch-/230617812846?pt=Radio_Control_Vehicles&hash=item35b1e48f6e
I have a few of them from single channel ones up to a 12 channel one.
They are handy for projects and hobbyist toys for sure.
The seller on eBay is ColdfusionX Electronics.