12v / 12 channel remote control

strobe dave

New elf
Joined
Dec 17, 2010
Messages
14
hi again all,
along with my vixen running my lights i also have a few static 12v DC lights to turn on for my display, i came across this on ali express and wondered if anyone has used these before. as it would make life a lot easier for me to turn them on.
http://www.aliexpress.com/fm-store/507574/211271126-502660166/Free-shipping12V-12-CH-Radio-Controller-RF-Wireless-Remote-Control-Switch-system-transmitter-and-receiver-.html.
cant quite make out the wire set up but it does say can be used for 12v DC.
 

David_AVD

Grandpa Elf
Community project designer
Generous elf
Joined
Jun 12, 2010
Messages
4,681
Location
Victoria Point (Brisbane)
That board looks like it should switch low voltage ok. Pay no attention to the 20A @ 14V relay rating as that's pure fantasy. Without seeing a board close up, I would only trust the switching for 5A max due to the PCB tracks. Those terminal blocks would be rated to 10A I'd say.
 

Superman

I Have C.L.A.P and its very infectious
Global moderator
Joined
May 29, 2010
Messages
1,778
Location
Ipswich-QLD
There was one od these or very similar at the Melb Mini last year in a LOR setup. It was used to trigger inputs on LOR boards for stand alone operation. Worked very well.
 
Top