2.8 Scheduler

Discussion in 'LightShow Pro (LSP)' started by cscool36, Nov 9, 2013.

  1. cscool36

    cscool36 Full Time Elf

    Joined:
    Jan 9, 2011
    Messages:
    154
    Likes Received:
    0
    Location:
    Belrose NSW
    Hi All,
    Just having problems with loading my programs to start.
    I have configured in LSP and all is working when played.
    I am getting an error message that Protocol and zones are not configured. Attached a screen shot.
    Thanks
    Colin
     
  2. AAH

    AAH I love blinky lights :) Community Project Designer

    Joined:
    Dec 27, 2010
    Messages:
    2,507
    Likes Received:
    1
    Location:
    Eaglehawk
    Find Me On:
    I might be wrong as I've never used the LSP scheduler but I read that error as being a possible conflict on zone 1 being configured as both DMX pro and also E1.31. DMX pro is pretty uncommon and Open DMX is usually used. Not a real lot of users use both a USB dongle and E1.31.
     
  3. OP
    OP
    cscool36

    cscool36 Full Time Elf

    Joined:
    Jan 9, 2011
    Messages:
    154
    Likes Received:
    0
    Location:
    Belrose NSW
    Hi AAH
    Thanks for the tip. I have changed the zones but still having the some problems.
    It works in 2.5 scheduler but not in 2.8.
    Colin
     
  4. DeeJai

    DeeJai Is that Magic Smoke?!?

    Joined:
    Oct 18, 2011
    Messages:
    1,007
    Likes Received:
    0
    Location:
    No longer in Radelaide
    is it possible to set these up on seperate zones?
     
  5. OP
    OP
    cscool36

    cscool36 Full Time Elf

    Joined:
    Jan 9, 2011
    Messages:
    154
    Likes Received:
    0
    Location:
    Belrose NSW
    I think I've found the problem.
    You also need to configure the outputs in the scheduler as well.
    I have the DMX on zone 1 and the E1.31 on zone 2.
    Now doing some testing.
    Thanks
    Colin
    Colin
     

Share This Page