vincerules
Full time elf
- Joined
- Aug 3, 2012
- Messages
- 100
I am trying to light these 12V LED strips with this DMX controller from Ray Wu through a ECG-D2. I have the cat5 cable plugged into port 1 on the ECG-D2 then the orange and orange/white cables going to the DMX + and - on the DMX controller. I have 12V power going to both devices.
How should the LED strip be connected to the DMX controller? It has 4 output pins and this is where I am confused. The LED strip lights up if i connect it straight to the 12V supply, so I know it works. but I can't figure out how to control it using this DMX controller.
Any ideas? Please let me know if you need any other info on my setup and/or pics. Thank you.
How should the LED strip be connected to the DMX controller? It has 4 output pins and this is where I am confused. The LED strip lights up if i connect it straight to the 12V supply, so I know it works. but I can't figure out how to control it using this DMX controller.
Any ideas? Please let me know if you need any other info on my setup and/or pics. Thank you.