Attempting to connect open DMX to LOR system and failing?

TroyMann

New elf
Joined
Dec 31, 2011
Messages
8
Ok I must be missing something because I have been researching and can not find anything about getting LOR hardware to recognize the Enttec open DMX.[/size]I have the Enttec open connected to the computer. I have a DMX 6803 decoder connected to the Enttec and the strip connected to the decoder. I no I am running the device through com 9 so I manually set the port to that in the hardware program. I go to refresh unit to configure and it comes up with 0 units found.What am I missing?
 

cenote

Suburbs of Philadelphia
Joined
May 16, 2010
Messages
246
Location
Pottstown, PA USA
Simple Quick looks:
Be sure you have the LOR control panel loaded in windows tray
Check your setting under network pref, in sequencer

It will not be shown in your hardware utility program, must run under sequencer or run a show
 

Benslights

Dedicated elf
Joined
May 2, 2010
Messages
2,868
Location
Elderslie
Also do you have S3 Advance as you need that to run DMX and you will need to find the LORcommlistener.exe in your lor files and run it. then when you get the gongle sorted out you can have some dmx fun.
 
Top