1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

Cannot find the posts on the T connectors custom that Ray says he will sell

Discussion in 'Computers, Cabling & Other Miscellaneous Hardware' started by arw01, Feb 28, 2014.

  1. arw01

    arw01 Full Time Elf

    Joined:
    Dec 30, 2013
    Messages:
    384
    Likes Received:
    1
    Location:
    Eastern Washington
    Ok poked around a lot with core ray store, connectors, etc etc I cannot find the posts where a couple of members were trying to get Ray to make some custom T connectors to inject power etc. I wanted to find out the feedback from members on those.


    Need to order some pixicles stuff and if those are not going to fly then will just go the normal 4 core T's.


    Alan
     
  2. Habbosrus

    Habbosrus New house (again) 2017

    Joined:
    Dec 5, 2012
    Messages:
    750
    Likes Received:
    0
    Location:
    Swansea, NSW
    Find Me On:
    This is the T type splitter I enquired about with Ray, but it's more for passing data along. T type connector.

    I haven't been advised that it is available yet, but Ray did say in an email that it was being put into production.
    [SIZE=small]There was an enquiry sent to Ray by another member about a T connector for power injection but I'm not sure where that's up to either.[/SIZE]
     
  3. mborg10

    mborg10 Michael Borg

    Joined:
    Dec 28, 2011
    Messages:
    1,446
    Likes Received:
    0
    Location:
    claremont meadows
    I enquiried about the power injection t splitters. He told me he had them. I emailed him for a quote on an order close to 2 weeks ago and no response. I'll email him again soon to say what's going on.
     
  4. OP
    OP
    arw01

    arw01 Full Time Elf

    Joined:
    Dec 30, 2013
    Messages:
    384
    Likes Received:
    1
    Location:
    Eastern Washington
    I also emailed him that and about 20 other questions related mostly to pixicles.


    Alan
     

Share This Page