1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

Change intensity of sequence

Discussion in 'LOR General Discussion' started by yzguy96, Dec 17, 2012.

  1. yzguy96

    yzguy96 Full Time Elf

    Joined:
    Sep 24, 2012
    Messages:
    174
    Likes Received:
    0
    Location:
    Chicago
    Hi,Is there an easy way to change the intensity of the whole sequence all at once in LOR? Seems like when i run on high intensity 100% it introduces either power issues or something cause it flickers and sometimes colors are off especially on white...if i can decrease the intensity i think it would eliminate most of the noise.
     
  2. hdracer

    hdracer There is no rehab for the CLAP

    Joined:
    Feb 17, 2012
    Messages:
    176
    Likes Received:
    0
    Location:
    Sugar Land,Tx
    You can scan overall of the sequence asif to copy. Hit "I" on keyboard and ll highlighted will go to 50% intensity. This would be easiest way of turning all channels intensity down.
    Hope this helps
     
  3. Kaden

    Kaden Pixels! I need more pixels!

    Joined:
    Jan 10, 2012
    Messages:
    724
    Likes Received:
    0
    Location:
    Gold Coast

    Unfortunately that does not work, it just sets all the RGB channels to 50% (ie half white) in that cell rather than 50% of the colour in the individual cell.
     

Share This Page