Porsche
Full time elf
Hi guys, I've searched this through and through and cant find that pic/diagram going around showing an Rj45 being soldered on the Ray 27's controller. I'm sure I've seen it on here before but some time ago!!!!!.
Basically, I've bought some new enclosures this year for the boards and the XLR pins once connected are getting a bit bulky, so I want to rip them out and change them over to Rj45, or at least hook RJ45 sockets up to them somehow. If my memory servers me correctly the diagram I saw had the new plugs soldered to the XLR pins at the back.. Ideally, I'd like to rip them out and resolder the new ones in. Not sure how possible that would be or if anyone's done it.
Ive attached pic, this plug snapped off when dropped from the roof and hung by the XLR pin, haha.
Has anyone done this or would know which of these on the board are
Pin 1 (GND)
Pin 2 (-ve)
Pin 3 (+ve)
Cheers
Basically, I've bought some new enclosures this year for the boards and the XLR pins once connected are getting a bit bulky, so I want to rip them out and change them over to Rj45, or at least hook RJ45 sockets up to them somehow. If my memory servers me correctly the diagram I saw had the new plugs soldered to the XLR pins at the back.. Ideally, I'd like to rip them out and resolder the new ones in. Not sure how possible that would be or if anyone's done it.
Ive attached pic, this plug snapped off when dropped from the roof and hung by the XLR pin, haha.
Has anyone done this or would know which of these on the board are
Pin 1 (GND)
Pin 2 (-ve)
Pin 3 (+ve)
Cheers