Controller ports do not match

[Ray Led]

Hi Guys
have a question have a Pixlite 16 none of the ports in xlights align with the ports on my controller, so i cannot get all the universes to work as required. is a simple display just using strips as outlines. Have no errors on sequence or controller upload.
any help owould be appreciated.


regards

ray

 

[AAH]

Some pictures of your xlights config and also the Advatek helper are needed so we can give you some input.

 

[Ray Led]

Hi Alan

appreciate this

ray

 

[daunce]

I consider myself a newbie, but I found switching to advice in "The Death of Start Channels"
View: https://youtu.be/o6ROdEDhSMI
simplified my set up. Using 1 line per controller in xLights setup tab, and then using xLights to upload the configuration to the controller as Keith describes in his video at this point in time
View: https://youtu.be/xtemNvNfsMw?t=4810
.

It took me a while, but with the help of the built in tests within xLights, controller and FPP, I was able to fix up all my set up issues.

Sorry I'm not really troubleshooting your issue, but I'm hoping the above may help.

 

[OzAz]

Quick look I can't see anything particularly wrong, but I'm no expert

Only thing I might try is setting exact number of pixels on each port in the Advatek assistant instead of just max number you have.
I know some controllers don't care, but I know one of my types does.

 

[AAH]

Go into the display testing in xlights and turn on a prop at a time. If you have 12V strip you may have assigned 3 times as many pixels as it really has and that will get really messy when you have daisy chained props.

 

[Ray Led]

Hi Al

working on 5v strings in test the props don't all work so will be checking my programming (leaning towards dud controller).
will a[so get my head around the vidios suggested.

thank again

ray

 

[keithsw1111]

Dud controllers are rare. Most issues of self inflicted config problems.

 

[Ray Led]

probably right,will strip down display and build one at a time