Greg
New elf
I’m using Xlights to test my controller (Pixlite 16) and lights. The sequence/patterns are running fine but the lights are blinking and not fading smoothly, When I went into to the assistant to see if I could adjust the speed of the controller all I saw was a fast and slow button, the fast button was selected I guess by default, and when I choose the slow button and within a couple seconds all the stands of lights turned white and would not shut off unless I unplugged the controller?
I’m assuming this is a speed issue cause I had the same problem on My Joshau1 P12 card, I had the speed set at 3500 and once I reset the speed to 2400 the lights worked perfectly.
I don’t see a place to dial in the speed of the controller/lights? All I see is a fast/Slow choice, I’m using 16 2811 pixel strips (like a CCR Strip) for my CR tree.
Suggestions?
I’m assuming this is a speed issue cause I had the same problem on My Joshau1 P12 card, I had the speed set at 3500 and once I reset the speed to 2400 the lights worked perfectly.
I don’t see a place to dial in the speed of the controller/lights? All I see is a fast/Slow choice, I’m using 16 2811 pixel strips (like a CCR Strip) for my CR tree.
Suggestions?