Matt Smith
New elf
- Joined
- May 29, 2018
- Messages
- 7
Hi there,
Got a quirky idea I'm hoping will work. From my calculations so far it seems if I use 1.5mm cable with an 8A load i can only go about 10 metres before I lose too much voltage. (Feeding back in forward 4 Amps)
What I'm hoping to do is run a "delay" psu which essentially has
A long 10-30m 2 core cable with ground and signal from advatek to the strip (WS2812B so no clock line)
And then a psu on a seperate power point and run an extension cord to it to power inject that led strip
Is this possible? I can draw a diagram if it's not clear.
Got a quirky idea I'm hoping will work. From my calculations so far it seems if I use 1.5mm cable with an 8A load i can only go about 10 metres before I lose too much voltage. (Feeding back in forward 4 Amps)
What I'm hoping to do is run a "delay" psu which essentially has
A long 10-30m 2 core cable with ground and signal from advatek to the strip (WS2812B so no clock line)
And then a psu on a seperate power point and run an extension cord to it to power inject that led strip
Is this possible? I can draw a diagram if it's not clear.