1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

E1.31 Controller limited to 7 universes?

Discussion in 'LightShow Pro (LSP)' started by BradsXmasLights, Nov 19, 2013.

  1. BradsXmasLights

    BradsXmasLights WiFi Interactive

    Joined:
    Dec 23, 2010
    Messages:
    506
    Likes Received:
    10
    Location:
    Brisbane, Australia
    Find Me On:
    Consider this: 136x10 pixel matrix, so 1360 logical channels (4080 physical, 8 DMX Universes).

    I have entered this in to LSP as a single E1.31 controller and I see all 1360 channels appear in the channel Drawing tool. I can draw my 136x10 matrix no worries and all channels appear correctly in the display editor.

    However in the main editor, only the first 7 universes worth of channels appear when this controller is expanded. And only the 7 universes are being outputted, despite entering the channel number+count in the output config.

    Any ideas?
     
  2. OP
    OP
    BradsXmasLights

    BradsXmasLights WiFi Interactive

    Joined:
    Dec 23, 2010
    Messages:
    506
    Likes Received:
    10
    Location:
    Brisbane, Australia
    Find Me On:
    Doh, 1AM maths fal! :-[ LSP channel count was correct at 8 universes, however LSP was still not adding additional channels when I increased the channel count. Yet in a new test project (same channel numbers) it did work. Dodgy LSP!
     

Share This Page