hi guys,
Was looking to goto e1.31 instead of USB
so i can talk with my controllers from any PC in the house rather then a dedicated one connected to USB
with the e1.31 i know this is IP based
so would i need a e1.31 controller / gateway to then change to the RJ45 connectors for the DMX controllers to operate them ?
i will end up with about 4 controllers for my setup when i fainlly move it all over from standard power packs and power boards
i would like to do a setup like this
PC ---- ETHERNET ------e1.31----DMX-----dmx2-24----------dmx2-24--------dmx-2-24-----dmx36 --- terminate
i understand it all - except for the e131 - Dmx part
what equipment would i use here ?
i would rather run a Outdoor style ethernet cable to a e1.31 device outside ( then to the controlers) then have to put a NUC or Rasberrypi outside to connect USB to first and have to control it from there
Was looking to goto e1.31 instead of USB
so i can talk with my controllers from any PC in the house rather then a dedicated one connected to USB
with the e1.31 i know this is IP based
so would i need a e1.31 controller / gateway to then change to the RJ45 connectors for the DMX controllers to operate them ?
i will end up with about 4 controllers for my setup when i fainlly move it all over from standard power packs and power boards
i would like to do a setup like this
PC ---- ETHERNET ------e1.31----DMX-----dmx2-24----------dmx2-24--------dmx-2-24-----dmx36 --- terminate
i understand it all - except for the e131 - Dmx part
what equipment would i use here ?
i would rather run a Outdoor style ethernet cable to a e1.31 device outside ( then to the controlers) then have to put a NUC or Rasberrypi outside to connect USB to first and have to control it from there