powerfix
New elf
Hey,
Not sure where to post this - apologies if there is a more suitable place.
Just setup my HE123Mk2 and installed FPP 6.3 on the SD card. All was well. Have read the copious amounts relating to the licensing and purchased a 48 port license and got the key. So far, so good.
In the FPP 6.3 webapp, there is no mention of the HE123Mk2 as a valid option for the virtual EEPROM, and have accidently set it to BBB16v2 (seeing the word "Hanson", got a bit excited).
Can anyone please shed light on which cape to select and/or instructions to get this working? I seem to see the Hanson HE123Mk2 in xLights controller setup, and have pushed that across, but cannot get output, making me think that the EEPROM image is causing grief.
Thanks in advance.
Not sure where to post this - apologies if there is a more suitable place.
Just setup my HE123Mk2 and installed FPP 6.3 on the SD card. All was well. Have read the copious amounts relating to the licensing and purchased a 48 port license and got the key. So far, so good.
In the FPP 6.3 webapp, there is no mention of the HE123Mk2 as a valid option for the virtual EEPROM, and have accidently set it to BBB16v2 (seeing the word "Hanson", got a bit excited).
Can anyone please shed light on which cape to select and/or instructions to get this working? I seem to see the Hanson HE123Mk2 in xLights controller setup, and have pushed that across, but cannot get output, making me think that the EEPROM image is causing grief.
Thanks in advance.