randallr
New elf
I'm trying to convert my ~10k channels to run in Xlights. Here's my show breakdown-
268 LOR Channels to 22 CTB16's and iDMX1000 on LOR Regular
900 DMX to 6 CCR's, plus 6ch to CTB16 (star) on LOR AuxA
900 DMX to 6 CCR's on LOR AuxB
8454 DMX on e.131 Network (J1 P2's, P12, D2's) Universe #'s are not sequential and have gaps.
I've started with only cells used on original LOR Regular Network.
With xLights config set for 300 on LOR Regular, only 87 map. With config set to 800, only 257 map.
When I bumped it past 1000, it finally maxed out at 266, and sequence appears to play.
Once I move to DMX cells on the other networks, it goes to poop. 2865 did map. Lots of errors like CCR1 channel conflicts with CCR6. It apparently isn't distinguishing between AuxA and AuxB, or between B1 unit ID or B7 unit ID.
Any suggestions? I've attached both a layout and a screenshot of my xLights setup tab.
Thanks
Randall
268 LOR Channels to 22 CTB16's and iDMX1000 on LOR Regular
900 DMX to 6 CCR's, plus 6ch to CTB16 (star) on LOR AuxA
900 DMX to 6 CCR's on LOR AuxB
8454 DMX on e.131 Network (J1 P2's, P12, D2's) Universe #'s are not sequential and have gaps.
I've started with only cells used on original LOR Regular Network.
With xLights config set for 300 on LOR Regular, only 87 map. With config set to 800, only 257 map.
When I bumped it past 1000, it finally maxed out at 266, and sequence appears to play.
Once I move to DMX cells on the other networks, it goes to poop. 2865 did map. Lots of errors like CCR1 channel conflicts with CCR6. It apparently isn't distinguishing between AuxA and AuxB, or between B1 unit ID or B7 unit ID.
Any suggestions? I've attached both a layout and a screenshot of my xLights setup tab.
Thanks
Randall