1. Mini Planning & Registrations | Brisbane Mini, 24-25 June: register

My EtherConGateway Mounting Tray

Discussion in 'EthConGateway by Joshua 1 Systems' started by dmoore, Sep 4, 2010.

  1. dmoore

    dmoore http://www.HolidayCoro.com

    Joined:
    Apr 26, 2010
    Messages:
    586
    Likes Received:
    0
    Location:
    Houston, TX, USA
    I was maching some 1" (26mm) HDPE for some of my MegaBalls and I added in a "tray" just to keep the bottom and sides safe.
     

    Attached Files:

  2. KeithTarpley

    KeithTarpley New Elf

    Joined:
    May 9, 2010
    Messages:
    45
    Likes Received:
    0
    Location:
    Marietta GA USA
    Greetings,,,

    Nice. Now just need a clear cover...

    Keith
     
  3. fasteddy

    fasteddy I have C.L.A.P Global Moderator Generous Elf

    Joined:
    Apr 26, 2010
    Messages:
    6,460
    Likes Received:
    13
    Location:
    Albion Park NSW
    Find Me On:
    Yes very nice and it looks so snuggly in there, a clear cover and at night the ECG will be its own little light display with all those onboard LEDs flashing.
     
  4. j1sys

    j1sys There are no rules, and those are the rules. Community Project Designer

    Joined:
    May 19, 2010
    Messages:
    242
    Likes Received:
    0
    Location:
    Knoxville TN USA
    David -

    I know I just published them but please read the jumper setting section near the end of the 1 Sep 2010 assembly manual. You need to rotate the DMX/Renard jumpers 90 degrees. They should be side by side at right angles to the RJ45.

    Ed

    Pretty box!!
     
  5. dmoore

    dmoore http://www.HolidayCoro.com

    Joined:
    Apr 26, 2010
    Messages:
    586
    Likes Received:
    0
    Location:
    Houston, TX, USA
    Thanks - I couldn't quite make out the text diagram in the instructions.
     

Share This Page