Sups team!
My programming in LSP has discrete E1.31 'controllers' for the various elements....I view controllers in LSP as functional display elements rather than physical controller hardware.
So the curly question is, my ECGP12-PR will have a section of strip of 7m hooked into it that acts as a matrix. Connected to the tail of this strip will be 10 RGB modules for a completely different display segment. The 7m strip/matrix and 10RGB modules are in different areas of my programming and so have no consecutive LSP channel numbers (I start each display segment at a factor of 1000).
Can I setup the ouptut config with universe 1 start channel of 3001, channel count of 70 and another universe 1 start channel 8001, channel count 30, and have 100 channels nicely output to the ECG12-PR pixel port associated with that output universe?
My programming in LSP has discrete E1.31 'controllers' for the various elements....I view controllers in LSP as functional display elements rather than physical controller hardware.
So the curly question is, my ECGP12-PR will have a section of strip of 7m hooked into it that acts as a matrix. Connected to the tail of this strip will be 10 RGB modules for a completely different display segment. The 7m strip/matrix and 10RGB modules are in different areas of my programming and so have no consecutive LSP channel numbers (I start each display segment at a factor of 1000).
Can I setup the ouptut config with universe 1 start channel of 3001, channel count of 70 and another universe 1 start channel 8001, channel count 30, and have 100 channels nicely output to the ECG12-PR pixel port associated with that output universe?