1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

P2 output loss??

Discussion in 'EthConGateway by Joshua 1 Systems' started by Boof63, Dec 1, 2013.

  1. Boof63

    Boof63 Senior Elf Generous Elf

    Joined:
    Nov 7, 2011
    Messages:
    575
    Likes Received:
    30
    Location:
    Kadina
    Hi, have appeared to lose the output from P2 on output one, tested with multi metre and no volts compared to output 2. Tested with lights and da_E131 and confirms it, have looked and pcb but cannot see any problems, (have had experience in overcooking run so I know what to look for) as for rest of it no idea. Attachments below for perusal, any thoughts most appreciated thanks.

    boof63 :'( :'(
     
  2. cozbert

    cozbert Full Time Elf

    Joined:
    Sep 3, 2012
    Messages:
    138
    Likes Received:
    2
    Location:
    Whyalla SA
    are you feeding the power to your pixels thru the p2? from the photos it looks that way.
     
  3. OP
    OP
    Boof63

    Boof63 Senior Elf Generous Elf

    Joined:
    Nov 7, 2011
    Messages:
    575
    Likes Received:
    30
    Location:
    Kadina
    no separate pwr in from pwr supply, just cluttered :D
    Now have no output from 1 or 2 as well, will play and see and post back later, thank you coz for the query, it helps to keep the CLAP alive.
    cheers Boof63
     
  4. Habbosrus

    Habbosrus Back again

    Joined:
    Dec 5, 2012
    Messages:
    757
    Likes Received:
    17
    Location:
    Swansea, NSW
    Find Me On:
    So are you only running data and ground out of p2? I looked at p2's earlier and ended up going with e6804's. From memory only data & ground should output from p2 and power + ground from power supply directly to string/strip.
     
  5. OP
    OP
    Boof63

    Boof63 Senior Elf Generous Elf

    Joined:
    Nov 7, 2011
    Messages:
    575
    Likes Received:
    30
    Location:
    Kadina
    Yep Data and Gnd from P2 , All pwr from same ray wu pwr supply, but separate take offs from pwr brick, Need to order another P2 and hope I think.
    Cheers Boof63 :-[
     
  6. Habbosrus

    Habbosrus Back again

    Joined:
    Dec 5, 2012
    Messages:
    757
    Likes Received:
    17
    Location:
    Swansea, NSW
    Find Me On:
    Maybe an ACL member has a spare that could help you out???
     
  7. Benslights

    Benslights Dedicated Elf Global Moderator Generous Elf

    Joined:
    May 2, 2010
    Messages:
    2,434
    Likes Received:
    149
    Location:
    Elderslie
    Find Me On:

Share This Page