neilric99
Full time elf
Attached is a PDF on what I needed to do to configure my ECG-DR8 with 6 Slaves enabled and setup Madrix to output using Streaming ACN (E1.31)
Neil
In So Cal
Neil
In So Cal
Setting up your ECG and Madrix for streaming ACN (E1.31)
- Thread starter neilric99
- Start date
mrpackethead
Full time elf
Nice work Neil. 
riri7707
Full time elf
Perfect...
Very Clear details (saved on my laptop)...
Just messing the boards now...
too impatient...
I'm sure it will be better than Eiffel tower flashing lighting 8)
Frenchy Guy.... Henri
Very Clear details (saved on my laptop)...
Just messing the boards now...
too impatient...
I'm sure it will be better than Eiffel tower flashing lighting 8)
Frenchy Guy.... Henri
mrpackethead
Full time elf
Just a little addon hint for you.
I've noticed that sometimes when you go into device manager and change universe setting etc that every so often madrix will display the changes but won't actually make them.. Exiting out and restarting madrix seems to cure that problem, but it is a bit ugly.
I've noticed that sometimes when you go into device manager and change universe setting etc that every so often madrix will display the changes but won't actually make them.. Exiting out and restarting madrix seems to cure that problem, but it is a bit ugly.
JonB256
Full time elf
Looks like you need a Madrix Key!
mrpackethead
Full time elf
the demo will functionally run, but it will stop outputing for 10 seconds every minute. And then will stop outputing completely after 1 hour.