Setup of the F16v3

Bryan H

Bryan
Joined
Feb 15, 2017
Messages
181
Location
Tamworth
Hi, Guys, I will start this thread. I would like to see photos of how others are putting their F16v3 together. This is my setup which took me about 6 hours to build so far. I am yet to run the pigtails which I will do over the next week or two. The cabinet is lockable and will need an air vent for airflow.
 

Attachments

  • 20170629_180601.jpg
    20170629_180601.jpg
    822.1 KB · Views: 62
  • 20170629_181404.jpg
    20170629_181404.jpg
    897 KB · Views: 61
  • 20170629_181414.jpg
    20170629_181414.jpg
    731.3 KB · Views: 61

OzAz

Senior elf
Global moderator
Joined
Dec 29, 2015
Messages
997
Location
Newcastle
you may have to wait till next year to see mine.
looking good @hammo131 nice use of spiralwrap, just wondering where the pigtails will all fit?
 

darylc

404 darylc not found
Joined
Dec 8, 2012
Messages
1,146
@hammo131 - watch out for that red expansion board, I don't believe that will work. From what I hear, it might be possible to use with a slight mod - removing one of the pins but I've not seen those specific instructions be released yet.
 

Bryan H

Bryan
Joined
Feb 15, 2017
Messages
181
Location
Tamworth
@hammo131 - watch out for that red expansion board, I don't believe that will work. From what I hear, it might be possible to use with a slight mod - removing one of the pins but I've not seen those specific instructions be released yet.
Ok, looking at their manual it should work, but I have never used a falcon before. If that is the case, I should have got the 2nd board from you...
 

Bryan H

Bryan
Joined
Feb 15, 2017
Messages
181
Location
Tamworth
Photos of under the boards
 

Attachments

  • 20170629_192136.jpg
    20170629_192136.jpg
    701 KB · Views: 48
  • 20170629_192146.jpg
    20170629_192146.jpg
    689.3 KB · Views: 47
Top