Sydney/NSW Sydney Expo 2020 (aka Sydney Mini) interest

[Benslights]

Ok well, it is time to start organizing the Sydney Convention for 2020.


We are looking to have it in May next year.

Due to the Numbers at the Sydney convention, we need a lot of presenters and ideas for presentations. (plus it is not fair on the people that always do it as they miss out on talks they want to be a part of)


so please put your hand up for some topics

the way I look at it if you have been to a Mini in the past you are capable of doing a presentation.

I will be doing a presentation on - problem-solving

getting the best out of zoom

 

[Jarrad]

Maybe i could do one on beginners and what to expect from a new persons point of veiw into the hobby, just throwing that one out there. but it would be next to useless if there are a room full of season vets.

 

[OzAz]

Didn't get to do one of my presentations last year, not that I'm complaining. Good ole Keith and the non-stop questions he answered
Happy to help
Happy to do a presentation or two

 

[Jarrad33]

Im there. Im only new so I doubt ill be any help unless its steel work design or rigging works. I make the rest up as I go along

 

[Trevor Wimmer]

I will be there, Happy to do a Presentation on X-Shedule and how to set up a play list.

 

[Jarrad]

I will be there, Happy to do a Presentation on X-Shedule and how to set up a play list.

Im still not going to get in a plane with you at the controls

 

[lithgowlights]

Happy to do an FPP - setup, uploading from xLights, and BBB/P10 setup.

 

[RAMJET]

I'm planning on being there and sucking as much information from the likes of Lithgow, Ben, Keith etc. I would love to do a presentation but I would not value ad at this point.

 

[Troy ELD]

Cannot wait for the mini convention

 

[lithgowlights]

Cannot wait for the mini convention

That's only because after this year you want to hire a full enclosed semi trailer for Reds order

 

[fasteddy]

Ill be happy to throw my hand up for a presentation or two

 

[Bryan H]

All depending on where I am living and what the future holds with work, I am happy to do a short pressy. I will think of a topic and put it forward Ben.

 

[RAMJET]

I could do a preso of "what not to do" lol

 

[BradsXmasLights]

I'm in!

 

[Daniel1973]

if you are doing the round table idea again, I can bring my CNC and do a chat about enclosure boards etc.