Tried to configure the ECG-P2 but failed

Rxsd

New elf
Joined
Dec 22, 2014
Messages
12
Afternoon all
I do apologise for the long winded post
Sorry to be a pain but I thought I was going well with the ECG-P2 set up.
Connected the 5 meter 2811 10pcs-IC- and 30pcs-5050 RGB strip which I assume means 30 pixles
Typed in the 10.10.10.10. all good, put in password
Went to string configuration and activated the first universe
Selected 2811 pixels on both outputs
Numbered the first universe 1
Start at 1
Number of pixels 30
Left all the other boxes unchecked
Saved and rebooted
After the reboot all the pixels came on, all white
Went to IP Config and enabled e-1.31 and UBL
Ticked test pattern and rebooted
Nothing happened all the pixels stayed on
Where have I gone wrong, :(
I am using Cat 6 cable connected to my windows 8 laptop
Thanks for all your time, any advise much appreciated, have a good day
Ray :)
 

Rxsd

New elf
Joined
Dec 22, 2014
Messages
12
How does one post a photo ?

Ray
 

Attachments

  • config.jpg
    config.jpg
    1.2 MB · Views: 33

dale82

Senior elf
Joined
Nov 19, 2010
Messages
581
Location
Kingaroy
Your speed is set to 0, also you have both outputs set at 1. If you jump into chat as its easier to talk you through
 

Rxsd

New elf
Joined
Dec 22, 2014
Messages
12
All is good guys
We have blinky, red, green and blue with a white chaser
Thank you so much for all your help

Ray
:D
 

Rxsd

New elf
Joined
Dec 22, 2014
Messages
12
The speed is the only thing I changed Oh and the pixel count from 30 to 50

Again thanks guys
Ray
 
Top