Using a big PSU question

[Dreamin]

Hi,

I've changing my layout to improve the ease of use, and rather than add another power supply I bought a Meanwell 100amp 500W 5v powersupply to run the whole thing. Just wondering how everyone goes from the 3 PSU outputs to multiple controller inputs. Running my F16v3 + Expansion + Diff expansion so there's 4/5 connections there. I don't really want to just hope for the best, so would prefer that it's realiable and safe to use with the PSU.

TIA.

 

[scamper]

You could check Alan Hanson's web site, he some some fuse boards that might be of use

Hexfuse2 | Hanson Electronics

6 way fused power breakout pcb - mini fuses

www.hansonelectronics.com.au

 

[DarkwinX]

So I'm guessing with Alan's one you use only one of the negative terminals but 2 of the positive ones?

 

[djgra79]

So I'm guessing with Alan's one you use only one of the negative terminals but 2 of the positive ones?

My understanding is you only need to fuse the +pos wires not the -neg. So Alan's board you would just run 3x +pos wire in and 6x +pos wires out (you could double up one of the ins or outs if really needed to.)
Whilst a little more expensive, I use David_AVD's boards in some of my enclosures as they are a little bigger (4x in, 8x out) but also allows for both pos/neg wires to be fed in and out to make cabling (in my opinion) a little easier)

8 Way Fuse Board (Terminal Block Outputs) – da-Share

www.da-share.com

 

[Dreamin]

Thanks everyone. In the end I went for one of these https://www.jaycar.com.au/powertech-6-way-fuse-block-with-bus-bar/p/SZ2031 as it handles 100amp (PSU is 100amp) and can handle outputs up to 30amp per output and also covers the negative with a bus. Worked well and I even figured out how to wire up the Shelly 1PM thing too which had the strangest instructions ever.

 

[Adsy]

Thanks everyone. In the end I went for one of these https://www.jaycar.com.au/powertech-6-way-fuse-block-with-bus-bar/p/SZ2031 as it handles 100amp (PSU is 100amp) and can handle outputs up to 30amp per output and also covers the negative with a bus. Worked well and I even figured out how to wire up the Shelly 1PM thing too which had the strangest instructions ever.

I have been using these and the 12 way versions for a couple a years. Sure, they can take up some space but offer a lot of flexibility

 

[Skymaster]

I run two of those in my MT box. One on each PSU. They work a treat. I think I picked mine up off Amazon or eBay - worth shopping around for them - Jaycar can be a bit pricey at times.