In the past I’ve just purchased Pixels with pigtails fitted, as it makes it so much easier.
However, this year I thought I would get some 12mm Bullet Pixels to put into some props that didn’t have pigtails, to allow me to neatly customise the number of Pixels, as well as keeping down the cost.
However, unlike square pixels, I couldn’t see any arrow or anything that would show the direction the data would flow, so I’m unsure how to wire it up and hoping someone could assist.
When it didn’t work the first time, I then tried adding signal from the other end, but it still didn’t work. So, if I got it wrong the first time and connected it in reverse, would this have damaged the Pixels, and if so, is there any way to fix them (e.g. cutting off the first Pixel which may have been damaged)?
This is a link to Ray Wu’s store, to a similar string, but this one does appear to have a plug on one end, unlike mine.
https://www.aliexpress.com/store/pr...l?spm=2114.12010615.8148356.10.5d71cf77TIhblN
However, this year I thought I would get some 12mm Bullet Pixels to put into some props that didn’t have pigtails, to allow me to neatly customise the number of Pixels, as well as keeping down the cost.
However, unlike square pixels, I couldn’t see any arrow or anything that would show the direction the data would flow, so I’m unsure how to wire it up and hoping someone could assist.
When it didn’t work the first time, I then tried adding signal from the other end, but it still didn’t work. So, if I got it wrong the first time and connected it in reverse, would this have damaged the Pixels, and if so, is there any way to fix them (e.g. cutting off the first Pixel which may have been damaged)?
This is a link to Ray Wu’s store, to a similar string, but this one does appear to have a plug on one end, unlike mine.
https://www.aliexpress.com/store/pr...l?spm=2114.12010615.8148356.10.5d71cf77TIhblN