Wrapping Bushes?

[slw2206]

So I have 600 pixels sitting around with no plans. I asked my wife what props she'd like, but she immediately said she wanted the front bushes wrapped (theyre about 3ft diameter, recently pruned).
I'd like to put these pixela on the bushes for her, but what can I use to try to keep them in some uniform pattern so effects might actually make sense.
Doesn't seem that I can just wrap them like traditional lights. I also don't see any need to have pixela on the backsides as the house is 2ft away.
Anyone have suggestions? Thanks

 

[MikeKrebs]

Get some strips and put the pixels in the strips and then they will be "the same". You would only need a few pieces like left middle and right. Alternatively, don't worry about it. Make it close and just do it. If you use xLights, you can create a custom model for each bush after you install.

 

[slw2206]

I have some extra strips from making window outlines. Guess I could use it to make a "blanket" as you suggest. 100 pixels per bush x6 bushes would probably make a fairly dense "prop".