Ktag
Apprentice elf
Hi all,
I am having a configuration issue, or simply do not know how to configure the differential board correctly.
Setup: HE123-Mk2 - HE123-TX (Set on 17-32 side) - HE123-RX (connected to HE123-TX port 2 ie. should be ports 21-24 in xlights?)
My 1860 pixel matrix is set up in xlights as 3 strings, 10 strands, 62pixel per strand - bottom left wiring = all good here as can get it to work properly - see below.
Trying to set the matrix via the differential board - xlights visualiser - on to port 21 (auto populates port 22 & 23). Uploaded output, rendered sequence. BUT when run sequence (or test from xlights for that matter) only the bottom third of my matrix activates (happens to be the top third of any picture within the matrix!).
However, if I set it up via xlights visualiser to run direct from the HE123Mk2 and not via the differential boards, on ports 5 (auto populates 6 & 7). Uploaded output, rendered sequence of course. The matrix runs exactly as it should when connected directly to the HE123 board.
Additionally tried,
- swapping the network cable between the TX & RX boards
- using different ports on the HE123-TX board - adjusting visualiser, uploading output and re-rendering etc.
- searching web for "how to configure differential boards" etc..
What is wrong with my configuration of the differential boards? How can I correct this?
Thanks in advance
Glenn
I am having a configuration issue, or simply do not know how to configure the differential board correctly.
Setup: HE123-Mk2 - HE123-TX (Set on 17-32 side) - HE123-RX (connected to HE123-TX port 2 ie. should be ports 21-24 in xlights?)
My 1860 pixel matrix is set up in xlights as 3 strings, 10 strands, 62pixel per strand - bottom left wiring = all good here as can get it to work properly - see below.
Trying to set the matrix via the differential board - xlights visualiser - on to port 21 (auto populates port 22 & 23). Uploaded output, rendered sequence. BUT when run sequence (or test from xlights for that matter) only the bottom third of my matrix activates (happens to be the top third of any picture within the matrix!).
However, if I set it up via xlights visualiser to run direct from the HE123Mk2 and not via the differential boards, on ports 5 (auto populates 6 & 7). Uploaded output, rendered sequence of course. The matrix runs exactly as it should when connected directly to the HE123 board.
Additionally tried,
- swapping the network cable between the TX & RX boards
- using different ports on the HE123-TX board - adjusting visualiser, uploading output and re-rendering etc.
- searching web for "how to configure differential boards" etc..
What is wrong with my configuration of the differential boards? How can I correct this?
Thanks in advance
Glenn