Hopefully someone else is using j1sys stuf with vixen 3 and can shed some light on how to get it working. I set up a test string with 50 pixels. I cant get any output to the lights. I can see that data is traveling to the board. The light is flashing orange. The standard test sequence works as...
Pixad8
Now to next next issue...I set the dip switches to off,off,off,on in order to run the test pattern. Rebooted device and it worked beautifully. Only issue now is I can't get the test pattern to stop unless I force the boot loader to stay active.... When I set all dips to off and reboot...
Solved!
What I did. In the ubl, after reloading the hex file onto the pic. I clicked run application. Tried 10.10.10.10 again and whamo! HTML configure page came up!
I have managed to red lash my "older" pixad8, can connect to it with the UBL no issues. What isn't working is trying to type 10.10.10.10 into my browser. It times out trying to connect. any suggestions?
Hmmmmm.
I have an older pixad8 combo. I cant ping the board via cmd, and the UBL returns this message: please reset device and invoke bootloader.... i Have SW1 set to XX11 which should have it set to 10.10.10.10....no connectivity....power is on and i have a flashing D0 and a constant D1...