Can someone tell me the P12 latest version. I am running 3.3 and wanted to know if the controller will handle the new pixels that are being sold now. I know the san device controllers needed an update but the Falcons did not...
Thank you
I am running an ECG-P12S. I have 5 ports connected for 100 node 12v ws2811's. I am running Unicast from xlights to my controller. I can only get the first 50 nodes to light up on port 8. Ports 9-12 seem to work fine. Here is what I see from the status page and string config. Can someone take a...
I found the anwer I was looking for...I knew how to create the channel I just wasn't sure on how to copy/paste the colors from a previous regular LOR sequence to RGB...thanks for the replies....
Can anyone direct me to a link here or anywhere else that discusses how to convert one of my LOR sequences to RGB.
I know how to use Bob-O's Vegomatic and create all new RGB channels and add them to my LOR sequence. I want to know the easiest way to now take all my channels and move them to the...
Posting a question for those who use the P12R controller. I had been using my Ethernet connection up this point as my connection to the controller with a Cat 5 cable. The other day I hosed (burned out) my Ethernet Port. So I purchased an Adapter (USB to Cat5) to connect to my controller. I run...
I have to check that again..when I first started it up my plan was to test it in LOR. When I started LOR up the Blue light came on. I killed the scheduler and then saw the DMX listener Disabled and then I had a red light. I assumed that I had it running correctly, now I'm not sure.
Looking for some insight….I am running a P12R controller and ws2811 pixels .
I created my mega tree in xlights and imported that file to LOR. I ran a test sequence with dip switch 4 up and the pixels seemed to work fine. I ran a sequence from xlights and that seemed correct..(Colors matched) as...
Just want to be sure I have this configured right...I probably don't and I don't want to burn out my pixels if I made an error...
I have 12 WS2811 IP68 12v pixel (50 cnt)connected to a ECGP-12R. I string per bank
Power supplies are 2 12v 360W...
Math 0.3 watts per string *50 12v
3amps...
Thank you for responding...here is what I have
http://www.aliexpress.com/snapshot/259251871.html
/www.aliexpress.com/snapshot/259251870.html
The Power Supply will be on the lower part of the Tree, closer to the ground.
Need some ideas please. I am building a 12 Strip tree with Ray Wu's 2801 strips. I am using Ray Wu's 350W dual output 5V/350W Power supply. I have used 2 banks of the Power supply which are both connected to my J12 controller, 1 bank for each side of the controller. I am using Ray Wu's 4 pin...
Just wanted to introduce myself....ezimnow out of Charlotte NC and new to this site. LOR user for 4 years and experimenting with CCR's and DMX this year. I found tons of info on this forum and decided to become a member. I am using 160 channels in a full LED display incorporating all the...