I've got them setup on one port, xlights is saying each prop takes 2 channels, FPP is showing 3 channels, I would have thought they should be the same but it seems to work, is it possible to tell FPP to only use 2 channels, I've tried uploading from xlights but it doesn't seem to change FPP...
I was just thinking about this today.
in xlights each model takes up 2 channels but in FPP it shows 3 channels.
String 1, FPP Start channel 1, Wires to Terminals 1 & 2
String 2, FPP Start Channel 4, Wires to Terminals 3 & 4
String 3, FPP Start Channel 7, Wires to Terminals 5 & 6
I don't fully...
I have just set up the same board, this is what I did and it seems to be working ok.
I have the DC2-30 connected to port 1 of a HE123.
I hope this is useful.
Kim
Edit: After uploading from Xlights to FPP, in FPP go to Channel Outputs, the start channels of the DC2-30 will be overlapping...
I was wondering about fire restrictions or whether it was bad practice, like switchboards have to be non-combustible materials, I didn't think it would apply but better to ask.
I'll get my sparky to do the 240volt part but I didnt want to go too far in the wrong direction, sounds like its ok so...
Hi Alan,
Can I jump in and ask a question, in the setup you posted above you have the model as HE123, in the older instructions I've been following they showed FPP and variant F, is model HE123 the best to use?
Thanks
Kim