Like to give a big thanks to David from AVD.
I had problems with my DC48 board, sent it back Tuesday, David got it Wednesday,repaired it and its on its way back to me today. I will have all my lights going this year.
So thanks again David.
Well its next year, and I still haven't resolved my issues. And as usual, leaving it till the last minute.
I'm thinking its maybe a vixen setting or how I have set up my sequences.
I want to run both Renard and DMX, is there a trick/tip on how it should be set up, i.e can I only set say 50ch...
Success sort off. Found out need to activate an 'Add-in' (read the vixen wiki helps)
So now I can run my test sequence in a loop and it keeps on running. BUT if I stop and start the sequence it stops working.
If I just leave the sequence running, don't touch vixen at all, seems all ok and runs...
I got your program to work, I had to click on the open port button in settings to get it working. It tested ok, but when I close your program and run vixen, still the same problem.
I am having trouble getting DMX to run for more than about a minute.
My setup is as follows.
Computer-= P4 3gig with 1 gig ram Windows Xp
Show software =Vixen 2.1, with the Enttec Open DMX plugin,
tried Enttec DMX USB pro, couldn't get it to work at all.
Set channel count from 1 to 48, only...
I too saw these last year and ended up getting most of them for $5.00 each, most I paid was $10.00 waited till close to Christmas and after, also Son works for Coles, got a discount :)
I have tested them and they do need 31v dc to get full brightness from them.
Can someone please advise what...
Just a heads up that Coles have these out at $5.00 each today, not sure for how long they will be out. I cleaned out ours today (all whites, no coloureds left) 10 buckets.