Eddy,
When I first started I could not get the visualizer to create and map the matrix properly. So I was building them in the animator. That is when I first saw the issue in 2.5. In 2.8 I have been able to create the image and it shows up in the matrix animator, I was just curious as to why the...
OK, I went into the Matrix Animator and made a short video of what I am seeing and uploaded it here.
https://www.dropbox.com/s/scnak4xmy3u58am/Matrix%20issue.avi
Thanks
Lee
Also when I was watching the LSP tutorial on the "Right Click Menu" - Audio Visualizer they skipped right over the matrix part saying it was covered by its own video. Anyone know where that video is, I could not find it.
Thanks,
Lee
The new version still does not support greater then 100 pixels in either direction. I still can not select multiple cells (pixels). I can only click 1 cell at a time. Anybody found a way to quickly do animations from scratch. It does alright if you have the graphics and import.
I was able to use...
I made the changes, rebooted same issue. I started to pull it a little on the RJ45 plug and I saw the led on the DMX board flash as it is supposed too. It appears I have a bad RJ45 cable I will solider a new cable onto the board and test it again.
Thanks YL
I am having an issue with my P12S DMX ports. I have both set as active, only #2 has a yellow light and neither will operate a 27 channel easy DMX board. The DMX board shows a solid red signal led, and test mode lights the pixels.
Any ideas!
Thanks,
Lee
Now the next thing. I built the tree image as a matrix 150 rows x 12 col. it says it built the matrix,
"matrix map 7:25 PM 12 x 150" It did not generate the image and when I go into the matrix animation tool and choose the "matrix map 7:25 PM 12 x 150" it says it is not configured. Do I have to...
I have been trying to get all the images and matrices to save and show up for a new sequence. I put the controllers in the library then use them in the next sequence but all the data is not stored with them, channel config is gone and the images are not in the visualizer. How can I move the...
Thanks Mat,
I am using a tree, 12 strips x 150 pixels. I converted it to a AVI file 320 x 240 no compression and it does accept it into LSP, However it does not turn out very well. I have not used the matrix animator yet, I will try that.
Thanks,
Lee