Recent content by SallyMarie

I will do that. These are some of my oldest sequences. Maybe an effect is no longer compatible.

Strange that this error only seems to effect 2 songs. I found some older instances of this problem but didn't know if the solution would be the same with the latest version of Vixen. Let me know if you have a fix before I start to cry that I lost 2 of my songs! Thanks!

Thanks so much for all the good information. Please let me know if you figure it out!

I'm determined to work out all my kinks even though the seasons almost over.:( I have 2 pesky WS2811 12V pixels that refuse to play nice. In between song they are bright steady red. While the sequence is playing - they change colors and work fine. Even in the sequence if they are supposed to be...

Thanks for all your ideas and opinions. I'm in email negotiations right now.

Hello, I was working on my order for my 2017 show. Now that I've got this pixel thing all figured out, I was going to really go crazy this year and buy about 7000 pixels! I pulled out my receipts from 2 years ago - to make sure I ordered the same pixels as I have now...I was so surprised to see...

Thank you all for your ideas and comments! SO nice to have such a great community to turn to for information. It turned out even though I was following the wire chart from the web site - my wires were all mixed up. The power and ground were opposite of the wire guides I found on the web for the...

Thanks so much! I will take all your advice and check it out!

I just put together my brand new E6804 controller board. I was able to locate it on the network and I can see and change all settings! I have it hooked up to a 12V power supply. I have it set to play a test sequence. So Far So Good, right! As soon as I attach the pixel string to any of the...

Thank you both for your advice! I got it all working today. I took all of your advice and just started over. I checked all my settings and connections - checked my firmware and Unit ID numbers - checked my cables. I think I was interpreting the Unit ID to Starting DMX Address Table wrong. Once I...

Hello, I'm copying Bluzervic set up and trying to control my 3 LOR CTB16PC controllers via the J1sys DMX Bridge ECG-D4. I also have some LOR CCB's and LOR RGB dumb floods, but one thing at a time. I have updated the unit numbers for 3 LOR CTB16PC units to be 01 (for the first one) 17 (for the...