Checking through lighting configurations, it has been noticed that adding the node has put the lighting order out on the star/spinner/flake by one node.
When i added a null node on the pixlite 16 configuration software for the Star/spinner/flake 1(the once which has the long cable run and needed...
Hi Everyone,
Just opened Xlights and got a dialogue box stating that my graphics card software needs to be fixed or updated?? (not sure exact wording, except there was some chinese characters in it as well?)
Exiting out of the dialogue box the display picture of my house and lighting changed to...
Hi Ryan,
Thank you for your prompt reply and information.
I have made up a null pixel that plugs inline and it is now working as it should be.
Thank you gain.
Regards
Stephen
Hello,
I have made up 3 star/spinner/flakes with 156 pixel nodes, 12volt, WS2811 chip. I run a Pixlite controller. 2 of the star/spinner/flakes run well but the other which is further away seems to get stuck on a certain pattern, I am assuming once the data gets complicated it is freezing on the...
Hello,
Thank you for reading this.
I have made 3 star/spinner/flakes and made several sub models. I would like to program them so that they look the exactly the same and synchronized.
When sequencing the sub models on the star/spinner/flake is there a way to apply these affects to the sub models...
HI Everyone,
I have been looking everywhere and cannot find a video or document on custom programming.
I have made a coro board with a spinner, star and snow flake all-in-one.
I want to be able to highlight either just the spinner or the snow flake or the star with effects or have them all on...
Hi Djgra79,
Thank you for your reply.
I think it was a bug with an older version, I have updated the software and it now working. thank you again.
Regards
Stephen
Hi Everyone,
I have made a small custom star in xlights using a spreadsheet and have copied into a custom model. The model shows up on my Preview.
I would like to make several of these, i have tried to copy and make new ones but to no avail.
I would assume that highlighting the model in the...
Hello all,
I have a Mega tree and just cut out a 50 pixel star (5 points) for the top. Setting up the lights for a starting point, what does 'Bottom Ctr-CW' mean in Xlights?
Regards
Stephen