In the attached picture I have added my configuration, could I please get some feedback on errors or room to improve?
Also in the totals you will see that I have 1800 channels planned for this setup, do I simply run a single data wire to the section I need to start a new output???? The reason I ask is that each of my PixLite 16 outputs is only 512 channels (I think I have that correct).
So like power injection how do I add the new data outputs, or do I simply have to break up my plan into 512 channel lots?
I hope all that made a small amount of sense..
wce06
Also in the totals you will see that I have 1800 channels planned for this setup, do I simply run a single data wire to the section I need to start a new output???? The reason I ask is that each of my PixLite 16 outputs is only 512 channels (I think I have that correct).
So like power injection how do I add the new data outputs, or do I simply have to break up my plan into 512 channel lots?
I hope all that made a small amount of sense..
wce06