Hi all,
Im trying to cut the Arlec rope light from Bunnings. Its a 2 wire system. There are NO marks or shunt/bridge sections. Every 1m there are 2 resistors. 2 leds to the power input side, there appears to be only 2 wires. Hard to see though. So im trying to figure out where I can cut this rope. Any help, much appreciated.
Mal
Im trying to cut the Arlec rope light from Bunnings. Its a 2 wire system. There are NO marks or shunt/bridge sections. Every 1m there are 2 resistors. 2 leds to the power input side, there appears to be only 2 wires. Hard to see though. So im trying to figure out where I can cut this rope. Any help, much appreciated.
Mal