Case for Falcon 16v3

davenmarcia

New elf
Joined
Dec 12, 2017
Messages
37
Location
Shortland,
Hi I had a friend print one and it works well. Just wondering about the button extender/pusher he printed 7 to go in each hole but they don't work on the buttons or should it only be 1and use it to poke from the outside?

Dave
 

AJ240

Up and running for 2019. Kick off Sun 1st 8pm
Generous elf
Joined
Dec 12, 2017
Messages
19
Location
Devon Place Narellan Vale Sydney
Hi I had a friend print one and it works well. Just wondering about the button extender/pusher he printed 7 to go in each hole but they don't work on the buttons or should it only be 1and use it to poke from the outside?

Dave
I think I know what went wrong. I uploaded the wrong version of these buttons. I bet you have the ones without the solid base.
Have a look and see if there is a hole in the base ? If so then fill it and it should work fine. My plan was to glue these to the buttons on the Falcon.
Let me know how you go.
 

davenmarcia

New elf
Joined
Dec 12, 2017
Messages
37
Location
Shortland,
I think I know what went wrong. I uploaded the wrong version of these buttons. I bet you have the ones without the solid base.
Have a look and see if there is a hole in the base ? If so then fill it and it should work fine. My plan was to glue these to the buttons on the Falcon.
Let me know how you go.
That's correct i have the ones with a hole. I will fill the holes thanks for a great case.
Dave
 
Top