1. New to Christmas lighting? Get started with the AusChristmasLighting 101 Manual:
    auschristmaslighting.com/wiki/AusChristmasLighting-101

Connecting DC48's to Ray Wu's 27 ch controller

Discussion in 'Computers, Cabling & Other Miscellaneous Hardware' started by Porsche, Dec 2, 2012.

  1. Porsche

    Porsche Full Time Elf

    Joined:
    Nov 7, 2012
    Messages:
    165
    Likes Received:
    0
    Location:
    Perth, Piara Waters
    Gday guys, does anyone know how to hook up DC48 (RJ45 connection) to Ray Wu's 27 ch controller (3 pin XLR). ive been looking on line etc on how to wire up a cat5 cable to a 3 pin XLR.
    all I can understand is that each controller is wired up differently and the wire configuration is different between controllers.
    Cheers
     
  2. David_AVD

    David_AVD Bite my shiny metal ass!

    Joined:
    Jun 12, 2010
    Messages:
    3,408
    Likes Received:
    43
    Location:
    Victoria Point (Brisbane)
    Find Me On:
  3. OP
    OP
    Porsche

    Porsche Full Time Elf

    Joined:
    Nov 7, 2012
    Messages:
    165
    Likes Received:
    0
    Location:
    Perth, Piara Waters
    Thanks David, I did see that chart but wasnt sure which was applicable to your controller.
    If i went by the ESTA configuration, would that work??
     
  4. David_AVD

    David_AVD Bite my shiny metal ass!

    Joined:
    Jun 12, 2010
    Messages:
    3,408
    Likes Received:
    43
    Location:
    Victoria Point (Brisbane)
    Find Me On:
    Yes, all of the AVD products use the ESTA standard pinout.
     
  5. OP
    OP
    Porsche

    Porsche Full Time Elf

    Joined:
    Nov 7, 2012
    Messages:
    165
    Likes Received:
    0
    Location:
    Perth, Piara Waters
    Thanks David, will do that.
     

Share This Page