DMX to LOR Cable adaptor

Superman

I Have C.L.A.P and its very infectious
Global moderator
Joined
May 29, 2010
Messages
1,778
Location
Ipswich-QLD
I was getting frustrated with making swap over cables to run LOR controllers in a DMX universe so i made a couple of these up. After I pulled it open it was just lengths of cable in it joining one end to the other so I did some cutting and re-joining and made an adaptor so all my cables can just be made as standard straight through cables and I can pop one of these into the line when I'm joining a LOR controller in between DMX ones. Information on which pins are which when doing this can be found in this thread.
00140-0013.jpg
 

Superman

I Have C.L.A.P and its very infectious
Global moderator
Joined
May 29, 2010
Messages
1,778
Location
Ipswich-QLD
Yes. But yours is a 2 way one. mines not. Very nice board David. do you have a little case for it?
 

fasteddy

I have C.L.A.P
Global moderator
Joined
Apr 26, 2010
Messages
6,648
Location
Albion Park NSW
I like that very much David, I have a heap of RJ45 F/M sitting around so im wondering how much would the board cost
 

David_AVD

Grandpa Elf
Community project designer
Generous elf
Joined
Jun 12, 2010
Messages
4,681
Location
Victoria Point (Brisbane)
People seem to get so confused when making custom cables, I thought a little PCB might be handy. :)

I'll post some more details once the samples come back next week.

Sorry to hijack your thread Steve. Thought I might save your fingers. (opening up those couplers)
 

Superman

I Have C.L.A.P and its very infectious
Global moderator
Joined
May 29, 2010
Messages
1,778
Location
Ipswich-QLD
Damn I just ordered a Hundred and was going to convert them and flog them off. LOL
 

Superman

I Have C.L.A.P and its very infectious
Global moderator
Joined
May 29, 2010
Messages
1,778
Location
Ipswich-QLD
I got them thru on of my wholesalers, I'd be fairly certain most of them would be cables inside.
 
Top