Hi All,
Long time since I've been here and after a couple of years collecting dust I've just put my lights out. I run an ECG-D2 to a 27 channel controller for the old Big W 3 wire strings. The ECG-D2 was always a pain, locking up, not powering up properly....and now its just cactus (the ethernet does not light up and the DMX LED is solid on, the same behaviour it used to show when it locked up or didn't power on properly....but its just not recovering).
What are the goto E1.31 to DMX boards? I'm also running FPP on an old Rasperry Pi that talks E1.31 to the ECG-D2 and a pixel controller, so not too sure if that will provide other options.
Long time since I've been here and after a couple of years collecting dust I've just put my lights out. I run an ECG-D2 to a 27 channel controller for the old Big W 3 wire strings. The ECG-D2 was always a pain, locking up, not powering up properly....and now its just cactus (the ethernet does not light up and the DMX LED is solid on, the same behaviour it used to show when it locked up or didn't power on properly....but its just not recovering).
What are the goto E1.31 to DMX boards? I'm also running FPP on an old Rasperry Pi that talks E1.31 to the ECG-D2 and a pixel controller, so not too sure if that will provide other options.