I have been using this e6804 for the past two months with testing pixels and everything. I also have two other e6804's. For some reason I now have this e6804 in place, ran it in test mode most of the evening yesterday and it ran great with no problems along with the two other e6804s. Tonight I run all my ethernet and setup my pi and now this one e6804 does not want to power up. Both the red light and green light do not light up at all. The ethernet jack does light up and indicate its connected to the network. I even disconnected all the wires so only the power was connected and the green and red indicators do not light up at all. Anyone know what my issue may be? I did not email Jim yet as I was hoping its something stupid that I can test for. Would suck if the board is shot as it will be the second one to do that to me and will probably be the end to my halloween display till I get a new one hopefully before christmas display. Sucky part is that board has been running beautifully for the past couple months during testing and even ran great yesterday..