jamesssydney
New elf
- Joined
- Sep 24, 2012
- Messages
- 42
Evening all.
I'm trying to get a 120 pixel strip to work using LOR and an ECG-P2. I'm running LOR 3.10.12. I can get the strip working using DA-e131. I've connected the P2 via ethernet cable to the LOR USB485 adaptor, then to my PC. I've configured as follows.
[attachimg=1]
The ports also seem to be open. Should the two leds above the ethernet cable on the P2 blink, be steady or off?
there currently off.
[attachimg=2]
I also ensure control lights under the play tab is selected. This give me the blue square in the bottom hand corner.
Below is an example of my channel config
[attachimg=3]
Not if I'm missing anything but any help would be much appreciated
Kind regards
JS
I'm trying to get a 120 pixel strip to work using LOR and an ECG-P2. I'm running LOR 3.10.12. I can get the strip working using DA-e131. I've connected the P2 via ethernet cable to the LOR USB485 adaptor, then to my PC. I've configured as follows.
[attachimg=1]
The ports also seem to be open. Should the two leds above the ethernet cable on the P2 blink, be steady or off?
there currently off.
[attachimg=2]
I also ensure control lights under the play tab is selected. This give me the blue square in the bottom hand corner.
Below is an example of my channel config
[attachimg=3]
Not if I'm missing anything but any help would be much appreciated
Kind regards
JS