TigerDMX120v1 Firmware Release 1.03.00 for PIC 2553

[AussiePhil]

All

Release 1.03.00 for the PIC2553 if used to build a T120

this is just a compile of the 2550 code for the 2553 pic, unable to directly test hardware but a PIC can be programmed.

EEPROM is set by default to start Channel 1

Please report issues in the thread and via PM

Phil

 

[Blickensderfer]

Phil,

I just tested the firmware on the 2553 and it's a no go.. I get the following leds on. 5 volt good, and the Output On and PIC active leds are on but had a random flicker.


Correction!!!!!!!!!

I did get it to work.. I didn't know that the jumpers had to be on the TX and the RX pins.. Once I did that it came alive.. I had to watch the 3rd part of video to see the jumpers.


Now the only thing is the additional starting channel settings.

Thanks,
Dan

 

[Blickensderfer]

Phil,

I don't know if it has to do with the firmware or not but when fading the leds either by manual test channel or within sequence, a quick fade to off. The leds flicker. It's not a real bad flicker but noticable. I have tried it on a couple different Tiger boards and effects are the same.

Thanks,
Dan

 

[fasteddy]

Phil,

I don't know if it has to do with the firmware or not but when fading the leds either by manual test channel or within sequence, a quick fade to off. The leds flicker. It's not a real bad flicker but noticable. I have tried it on a couple different Tiger boards and effects are the same.

Thanks,
Dan

Are you using LSP and the ECG.

 

[Blickensderfer]

No.. I'm using Vixen and a Enttec Open to test with. I do have an Enttec Pro and ECG. I can try testing one of them but I also have a Lynx Express controller attached too. The flicker doesn't happen on the led status. But this isn't compairing apples to apples. different technologies.