Porsche
Full time elf
I unpacked my Ray27's last night to test them all. I havent used these controllers before.
I hooked them up Via E1.31 and ran Da E1.31 test pattern to make sure they worked.
I had a Ray hooked up to my D4 port 1 on universe 6. When I ran Da E1.31 on universe 6 I couldnt test the lights. The Red light on the Ray board was on solid (not flashing), but when I changed the Da1.31 to another universe the red light on the Ray would flash and automatically run a test pattern. So Im assuming they have a test pattern built in to the Rays.
Is there anything specific I should have done when I first got these boards, like install drivers etc.
When the Red LED on the board is on solid or flashing what does that mean. Why couldnt I get Da1.31 to talk with the boards?
I even tried setting DIP switches to like channel 50 and then running Da1.31 to start at channel 50. but nothing.
What have I missed?
Cheers
Phil
I hooked them up Via E1.31 and ran Da E1.31 test pattern to make sure they worked.
I had a Ray hooked up to my D4 port 1 on universe 6. When I ran Da E1.31 on universe 6 I couldnt test the lights. The Red light on the Ray board was on solid (not flashing), but when I changed the Da1.31 to another universe the red light on the Ray would flash and automatically run a test pattern. So Im assuming they have a test pattern built in to the Rays.
Is there anything specific I should have done when I first got these boards, like install drivers etc.
When the Red LED on the board is on solid or flashing what does that mean. Why couldnt I get Da1.31 to talk with the boards?
I even tried setting DIP switches to like channel 50 and then running Da1.31 to start at channel 50. but nothing.
What have I missed?
Cheers
Phil