xscheduler 2019.28 - No standalone option.

[cdjazman]

So I have installed xlights 2019.28 and looking at testing xscheduler and i cant access from my phone (on the same network) as i did with last year 2018.58.

Not sure if it is me or that there is not a standalone option that i ran last year. I used a minipc and ZERO raspberry pi units.

Any assistance would be great.

Thanx.

 

[keithsw1111]

Can you access it from the browser on the pc running xschedule.

 

[cdjazman]

Can you access it from the browser on the pc running xschedule.

Keith,

Do you mean the web interface? If so then yes on the machine pc running xschedule.

 

[keithsw1111]

Has your pcs up address changed. You should use the up displayed in the middle bottom of the xschedule screen.

 

[cdjazman]

it may have changed but yes i am trying to use the ip address shown at the bottom of xscheduler.

the previous version had standalone as an option. Is that just the default option now?

 

[keithsw1111]

Yeah we made it more flexible. Standalone is the same as having remote disabled and none of the master modes turned on.

It has nothing to do with the web interface. If you are using the right address then the most likely issue is a firewall issue.

 

[cdjazman]

Ok thanks Keith.

We did install NBN recently so will have to check that out.

Thanks again for your help.

 

[cdjazman]

Yeah we made it more flexible. Standalone is the same as having remote disabled and none of the master modes turned on.

It has nothing to do with the web interface. If you are using the right address then the most likely issue is a firewall issue.

And BANG..... run firewall to allow xschedule and "insert band fanfare here"

Thanks @keithsw1111
You da man.