coopz05
Apprentice elf
Hey guys,
Having some issues getting a data signal to my new AAMega60 DC Controller.
A massive thanks goes to AAH for all his amazing help building my enclosure and putting up with my endless questions.
Basically I want to have a 16ch LOR 240v as my first 16 channels, then I want to daisy chain that onto 3x AAHMega60 DC Controllers.
But at the moment I cannot get the data to the DC controller. (at this stage Im trying to get one to work, before I add the next 2)
The data is going to the 240v fine. That is playing every channel with no issues. I have then run a cat5 cable from the LOR to the DC controller.
I have set the jumpers on the MEGA60 to LOR.
I have set my sequence channel settings as follows:
Device: DMX
Universe: 2 (I have tried on Universe 1 too, should it be 1 because its under 512?)
Circuit: 1, 2, 3, etc etc
Can someone see anything I'm doing wrong?
Having some issues getting a data signal to my new AAMega60 DC Controller.
A massive thanks goes to AAH for all his amazing help building my enclosure and putting up with my endless questions.
Basically I want to have a 16ch LOR 240v as my first 16 channels, then I want to daisy chain that onto 3x AAHMega60 DC Controllers.
But at the moment I cannot get the data to the DC controller. (at this stage Im trying to get one to work, before I add the next 2)
The data is going to the 240v fine. That is playing every channel with no issues. I have then run a cat5 cable from the LOR to the DC controller.
I have set the jumpers on the MEGA60 to LOR.
I have set my sequence channel settings as follows:
Device: DMX
Universe: 2 (I have tried on Universe 1 too, should it be 1 because its under 512?)
Circuit: 1, 2, 3, etc etc
Can someone see anything I'm doing wrong?