I had some issues too but got them resolved, What issues are you having? When you say Communicate what do you mean? Are you able to see it in the LOR assistant? If you can detail the steps your using that would help us be able to diagnose the problem, Some screen shots would also be good to see
Hi Bill, The controller I can't see id hooked up to the same switch/hub as the other controllers (one network) , its an 8 port 100mb hub, It seems to be something with the hub, cause when I brought it in the house on my other switch it worked just fine? here is my set up
Computer IP 10.10.10.10...
I was able to see my 12Px when I was working on my matrix, it worked fine, I moved the matrix and controller to the roof and now I cant see the controller, I took it back down and when I play around like power down or restart my computer I can log in once and that's it?
Tried new network cables...
I was testing my P12s for my show and after the test the lights did not go off. I stopped the player (LOR) and even unplugged the cat5 for the E1.31 and the lights stayed on?
I then unplugged the power to the board, the lights went off but as soon as I plugged the power back in (right away)...
Thanks for the suggestions, however; it was as simple as stopping/dumping the LOR system tray as it still sends commands even thought the Sequencer is not running
I’m using Xlights to test my controller (Pixlite 16) and lights. The sequence/patterns are running fine but the lights are blinking and not fading smoothly, When I went into to the assistant to see if I could adjust the speed of the controller all I saw was a fast and slow button, the fast...
I'm new to X-lights (working with version 4.24) I'm working on a 12 string x 50 pixel horizontal matrix. I have everything hooked up correctly and can control the effects to the matrix.
My problem is in scrolling text, As an example I use Merry Christmas with an Arial font and the text scrolls...
Thanks you so much, How would I set these up for my display? This is only my second year with LOR/DMX, Can it be done with these types of devices or does it require a whole other program/application to run?
Hi Greg, I see your also located in California as well? I am building a horizontal matrix and I used 3" spacing but I can not make out the text and graphics very good. What spacing did you use for your matrix? My current set up is 12 strips x 50 pixels.
Greg
The cable from the controller to the pixels was only 8-ft so I figured it wasn't the length of the cable, I just really didn't know anything about the Baud rate/speed. Is there anything out there that has some detail on exactly what the card baud rate and speed does? I understand its a...